Netgear WNR612v2

Netgear WNR612 v2

Manuf (OEM/ODM): Delta Networks

FCC approval date: 01 April 2010
Country of manuf.: China
Series: N150

Type: wireless router

FCC ID: PY309400124
PCB ID: 2976352402

Power: 7.5 VDC, 1 A
Connector type: barrel

CPU1: Atheros AR7240 (400 MHz)
FLA1: 4 MiB4,194,304 B <br />32,768 Kib <br />4,096 KiB <br />32 Mib <br />0.00391 GiB <br /> (Macronix MX25L3205DM2I-12G)
RAM1: 32 MiB33,554,432 B <br />262,144 Kib <br />32,768 KiB <br />256 Mib <br />0.0313 GiB <br /> (Hynix HY5DU561622FTP-D43)

Expansion IFs: none specified
Serial: yes, 4-pin header

WI1 chip1: Atheros AR9285
WI1 802dot11 protocols: bgn
WI1 MIMO config: 1x1:1
WI1 antenna connector: none

ETH chip1: Atheros AR7240
Switch: Atheros AR7240
LAN speed: 100M
LAN ports: 2
WAN speed: 100M
WAN ports: 1

bgn

TPFirmware supported: OpenWrt • (List | Dev | DLs)

Default SSID: NETGEAR (44 addl. devices)
Default IP address: 192.168.1.1
the IP 192.168.1.1 is used by 1297 additional devices
of which 105 are Netgear devices
Default login user: admin
Default login password: password
admin:password credentials used by 421 additional devices
of which 302 are Netgear devices

802dot11 OUI: 30:46:9A (11 E, 14 W), A0:21:B7 (9 E, 8 W), C0:3F:0E (14 E, 12 W)
Ethernet OUI: 30:46:9A (11 E, 14 W), A0:21:B7 (9 E, 8 W), C0:3F:0E (14 E, 12 W)

	FCC ID
On Networks (Netgear) N150R	PY309400124

	CPU1 brand	WI1 chip1 brand	WI1 chip2 brand
Netgear WNR612v2	Atheros	Atheros
Netgear WNR612v3	Realtek	Realtek

For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.

---

N150 Wireless Router

 • Support page

On the Netgear GPL sources page

Netgear's GPL sources directory on their FTP server

"2976352402" is silkscreened on the board in the FCC photos.

• Netgear WNR612 v2 on OpenWrt wiki
• Images and screenshots (RU)

Per this NETGEAR.ru forum post, A0:21:B7 is an assumed OUI of the device.

Atheros AR7240 device. The WNR612v1 may share the same basic hardware.

It shares all the hardware with WNR1000v2 and flashing it to WNR1000v2

firmware (over TFTP) works. The only difference is the number of LAN ports.

• The bootloader of the device uses a TFTP server. To access the TFTP server

the user must hold reset button before the device is powered on and keep on

holding it for a few seconds.