AT&T U-verse 5031NV

From WikiDevi.Wi-Cat.RU
Jump to navigation Jump to search

AT&T U-verse 5031 NV

Amazon image

ASIN
B00KXBNGNE (Flag of the United States.svg, On Amazon, On CCCmultiple uses)
multiple revisions of this device, use caution

Type: wireless router, dsl modem

Power: 12 VDC, 3 A
Connector type: barrel

CPU1: Broadcom Model?
FLA1: ? MiB (Brand? Model?)
RAM1: ? MiB (Brand? Model?)

Expansion IFs: none specified

WI1 chip1: Broadcom Model?
WI1 802dot11 protocols: bgn
WI1 MIMO config: 2x2:2
WI1 antenna connector: none

ETH chip1: Brand? Model?
LAN speed: 100M
LAN ports: 1

bgn

802dot11 OUI: none specified

For a list of all currently documented Broadcom chipsets with specifications, see Broadcom.


Product page (Pace 5031NV)

Rebranded Pace 5031NV which is a rebranded 2Wire 5031NV?

See also: Pace 5012NV

Bridging

There is no true bridge mode on the 2Wire routers. However, you can still configure

it such that almost all functions of your own router will work properly.
  1. Set your router's WAN interface to get an IP address via DHCP.
    This is required at first so that the modem recognizes your router.
  2. Go to Settings -> Firewall -> Advanced Configuration
  3. Uncheck the following: Stealth Mode, Block Ping, Strict UDP Session Control.
  4. Check everything under Outbound Protocol Control except NetBIOS.
  5. Uncheck NetBIOS under Inbound Protocol Control.
  6. Uncheck all the Attack Detection checkboxes (7 of them).
  7. Click Save.
  8. Plug your router's WAN interface to one of the 2Wire's LAN interfaces.
  9. Restart your router, let it get an IP address via DHCP.
  10. Log into the 2Wire router's interface. Go to Settings ->
    Firewall -> Applications, Pinholes, and DMZ
  11. Select your router under section (1).
  12. Click the DMZPlus button under section (2).
  13. Click the Save button.
  14. DO NOT reboot the modem as the settings will go all wonky and you will have to start over
  15. Reboot your router or renew the DHCP address, the Routers IP address should be your public IP