AVM FRITZ!Box Fon WLAN 7360 v2

From WikiDevi.Wi-Cat.RU
Jump to navigation Jump to search

AVM FRITZ!Box 7360 v2 (HW196)

(Est.) release date: June 2012

Series: N300

Type: wireless router, dsl modem, analog phone gateway

Power: 12 VDC, 1.4 A
Connector type: barrel
Conn. measurements: 5.5 mm (OD), 2.5 mm (ID), 9.5 mm (LEN)

CPU1: Lantiq PSB80920 (500 MHz, 2 cores)
FLA1: 32 MiB33,554,432 B <br />262,144 Kib <br />32,768 KiB <br />256 Mib <br />0.0313 GiB <br /> (Macronix MX29GL256EHT2I-90G)
RAM1: 128 MiB134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (Winbond W971GG6JB-25)

Expansion IFs: USB 2.0
USB ports: 2

WI1 chip1: Atheros AR9287
WI1 802dot11 protocols: bgn
WI1 MIMO config: 2x2:2
WI1 antenna connector: U.FL (internal)

ETH chip1: Lantiq PSB80920
ETH chip2: Atheros AR8030-A
ETH chip3: Atheros AR8030-A
Switch: Lantiq PSB80920
LAN speed: 2x 1GbE + 2x 100M
LAN ports: 4

bgn

Additional chips
xDSL AFE;Lantiq;PSB 80190;PSB 80190 V, V1.1, XWAY VRX208;1;
POTS/PSTN (DAA) Chip;Silicon Labs;IA3222B;;1;
POTS/PSTN (DAA) Chip;Silicon Labs;IA3223A;;1;
DECT Chip;Dialog;SC14441B;;1;

Flags: ADSL2+, VDSL, DECT, VoIP

Default SSID: FRITZ!Box 7360 (1 addl. devices)
Default IP address: 192.168.178.1
the IP 192.168.178.1 is used by 9 additional devices
of which 9 are AVM devices

802dot11 OUI: C0:25:06 (1 E, 1 W)
Ethernet OUI: C0:25:06 (1 E, 1 W)

For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.
For a list of all currently documented Lantiq (Intel) chipsets with specifications, see Lantiq.


AVM FRITZ!Box Fon WLAN 7360 Router

Support page  • Manual (en)
mips34_16MB_vdsl_dect441_2eth_2geth_1ab_2usb_host_wlan11n

Externals

  • 1× Combined FXO (POTS/PSTN, pins 3 and 6) and DSL (pins 4 and 5)
port with 8P8C connector
  • 1× FXS port (FON 1) with 6P4C connector and a discrete component
(apparently) driver (cf. IA3222 and IA3223 for POTS/PSTN port)
  • 4× Ethernet ports:
    • 2× Fast Ethernet (10/100 Mbit/s) ports
    • 2× Gigabit Ethernet (10/100/1000 Mbit/s) ports

Internals

Two-part plastic clamshell, with 4× T9 screws, 2 to the rear, 2 under the forward

LRF, and one clip center-front. No further tooled disassembly required.

There are 2× U.FL connectors on the cicuit board for the WiFi (not for DECT) antennae.

The device generates at least the following voltages internally:

  • From the Texas Instruments TPS65252 buck converter:
    • +3.3 V
    • +1.05 V
  • From a buck converter: +1.85 V
  • From a buck converter: +5 V
  • From a boost converter: +18.75 V

See also

FRITZ!Box Fon WLAN 7360 Versions on BoxMatrix Wiki