(Est.) release date: August 2014
Country of manuf.: China
Type: single-board computer
Power: 5 VDC, 2 A
Connector type: USB Female Micro-B
CPU1: Allwinner A20 (1 GHz, 2 cores)
FLA1: 0 MiB0 B <br />0 Kib <br />0 KiB <br />0 Mib <br />0 GiB <br /> (Brand? Model?)
RAM1: 1 GiB 1,024 MiB <br />1,073,741,824 B <br />8,388,608 Kib <br />1,048,576 KiB <br />8,192 Mib <br /> (SK hynix H5TQ4G63AFR-PBC × 2)
Expansion IFs: USB 2.0, SATA
USB ports: 2
SATA ports: 1
Serial: yes, 3-pin header, 3.3V TTL, (115200 8N1)
WI1 module: AMPAK AP6181
WI1 module IF: SDIO
WI1 chip1: Broadcom BCM43362
WI1 802dot11 protocols: bgn
WI1 MIMO config: 1x1:1
WI1 antenna connector: U.FL
ETH chip1: Realtek RTL8211E
LAN speed: 1GbE
LAN ports: 1
Flags: MicroSD Card slot, HDMI, A/V out (3.5mm), IrDA, GPIO
802dot11 OUI: none specified
For a list of all currently documented Allwinner SoC's with specifications, see Allwinner.
For a list of all currently documented Broadcom chipsets with specifications, see Broadcom.
- Product page (LeMaker)
- CPU: Broadcom BCM43362 ARM Cortex-M3 (WICED)
- Wi-Fi: AMPAK AP6181 - 802.11bgn (150Mbps)
- 1x GbE (10/100/1000) Ethernet RJ45 port
Serial
| Expand • iw list dump
|
Bananian Linux 16.04 / Debian GNU/Linux 8.4 (jessie)
linux-image-3.4.111-bananian_16.04.01 (ap6210 op_mode=2)
linux-firmware-image_16.04.01 (fw_bcm40181a2.bin Apr 22 2013 14:50:00
version 5.90.195.89.6 FWID 01-b30a427d)
Wiphy phy0
Band 1:
Capabilities: 0x1020
HT20
Static SM Power Save
RX HT20 SGI
No RX STBC
Max AMSDU length: 3839 bytes
DSSS/CCK HT40
Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
Minimum RX AMPDU time spacing: 16 usec (0x07)
HT RX MCS rate indexes supported: 0-7
HT TX MCS rate indexes are undefined
Frequencies:
* 2412 MHz [1] (20.0 dBm)
* 2417 MHz [2] (20.0 dBm)
* 2422 MHz [3] (20.0 dBm)
* 2427 MHz [4] (20.0 dBm)
* 2432 MHz [5] (20.0 dBm)
* 2437 MHz [6] (20.0 dBm)
* 2442 MHz [7] (20.0 dBm)
* 2447 MHz [8] (20.0 dBm)
* 2452 MHz [9] (20.0 dBm)
* 2457 MHz [10] (20.0 dBm)
* 2462 MHz [11] (20.0 dBm)
* 2467 MHz [12] (20.0 dBm)
* 2472 MHz [13] (20.0 dBm)
* 2484 MHz [14] (20.0 dBm)
Bitrates (non-HT):
* 1.0 Mbps
* 2.0 Mbps (short preamble supported)
* 5.5 Mbps (short preamble supported)
* 11.0 Mbps (short preamble supported)
* 6.0 Mbps
* 9.0 Mbps
* 12.0 Mbps
* 18.0 Mbps
* 24.0 Mbps
* 36.0 Mbps
* 48.0 Mbps
* 54.0 Mbps
max # scan SSIDs: 10
max scan IEs length: 2048 bytes
Retry short limit: 7
Retry long limit: 4
Coverage class: 0 (up to 0m)
Supported Ciphers:
* WEP40 (00-0f-ac:1)
* WEP104 (00-0f-ac:5)
* TKIP (00-0f-ac:2)
* CCMP (00-0f-ac:4)
* CMAC (00-0f-ac:6)
Available Antennas: TX 0 RX 0
Supported interface modes:
* managed
* AP
* monitor
software interface modes (can always be added):
interface combinations are not supported
Supported commands:
* new_interface
* set_interface
* new_key
* start_ap
* set_bss
* join_ibss
* set_pmksa
* del_pmksa
* flush_pmksa
* remain_on_channel
* frame
* frame_wait_cancel
* set_wiphy_netns
* set_channel
* connect
* disconnect
Supported TX frame types:
* IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
Supported RX frame types:
* IBSS: 0xd0
* managed: 0x40 0xd0
* AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
* AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
* P2P-client: 0x40 0xd0
* P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
|
Images
