Embest SBC-EC9100
Embest Technology SBC-EC9100 (REV 02)
(Est.) release date: June 2016
(Est.) initial retail price (in USD): $30
Type: single-board computer
Power: 5 VDC, 2 A
Connector type: barrel
Conn. measurements: 5.5 mm (OD), 2.1 mm (ID), 9.5 mm (LEN)
CPU1: Freescale (NXP) i.MX6ULL (528 MHz)
FLA1: 4 GiB 4,096 MiB <br />4,294,967,296 B <br />33,554,432 Kib <br />4,194,304 KiB <br />32,768 Mib <br /> (Micron MTFC4GLDEA-0M WT)
RAM1: 512 MiB536,870,912 B <br />4,194,304 Kib <br />524,288 KiB <br />4,096 Mib <br />0.5 GiB <br /> (Micron MTFC4GLDEA-0M WT)
Expansion IFs: USB 2.0, USB 2.0 (OTG)
USB ports: 2
Serial: yes, via GPIO header, (115200 8N1)
ETH chip1: Freescale (NXP) i.MX6ULL
ETH chip2: Microchip KSZ8081
LAN speed: 100M
LAN ports: 1
Additional chips
PMIC for i.MX6UL;NXP;MC34PF3001A7EP;;1;
High-Speed CAN Transceiver;NXP;MC33901;;2;
256Kb I2C Serial EEPROM;ON Semi;CAT24C256;;1;
Dual USB High-Side Power Switch;Sipex;SP2526A;;1;
Programmable-Delay Supervisory Circuit;TI;TPS3808;;1;
Full-Duplex RS485/RS-422 Transceiver;Analog Devices;ADM3485;;1;
Low-Voltage I/O Touch Screen Controller;Burr-Brown;TSC2046;;1;
Very Low Capacitance ESD Protection;STMicro;USBLC6-2;;2;
Low Capacitance TVS Diode Array;Semtech;SRV05-4;;2;
4-bit Low-Voltage FET Bus Switch;TI;SN74CB3Q3257;;1;
12V, 12A Single P-Channel PowerTrench MOSFET;Fairchild;FDMA908PZ;;2;
Stock bootloader: U-Boot 2015.04
Stock FW OS: Linux 3.14.52 Debian 8.4
Flags: MicroSD Card slot, MIPI CSI, CAN Bus, RS485, I2C, SPI, UART, GPIO
Default IP address: acquired via DHCP
the IP acquired via DHCP is used by 212 additional devices
of which 0 are Embest Technology devices
Default login user: debian
Default login password: debian
Ethernet OUI: none specified
For a list of all currently documented Freescale (NXP) SoC's with specifications, see Freescale.
SBC-EC9100
"SBC-EC9100 REV02" and "2016-6-2" is on top of board.
Links
Hardware specification
- CPU: Freescale (NXP) i.MX6ULL @528MHz
- MCIMX6G3DVM05AA • ARM (Cortex-A7)
- Memory: 512MB (DDR3L) SDRAM
- Storage: 4GB (eMMC) Flash
- Network: 1x FE port
- USB: 1x USB 2.0, 1x USB (OTG) ports
- GPIO: 2x 40-pin headers
- Power Source: 5V/2A via barrel
