Giga Devices G-POINT 802.11b/g PC Card
Jump to navigation
Jump to search
Giga Devices G-POINT 802.11b/g PC Card
Manuf (OEM/ODM): USI CB-G-BR-02
FCC approval date: 29 October 2003
Country of manuf.: Taiwan
Interface: PCMCIA (32-bit)
Form factor tags: Type II
ID: 14e4:4320 (33 addl. devices) SS: 1154:0324
Windows: PCI\VEN_14E4&DEV_4320&SUBSYS_03241154
FCC ID: IXMCB-G-BR-02
WI1 chip1: Broadcom BCM4306
WI1 chip2: Broadcom BCM2050
Probable Linux driver
b43legacy or b43, depending on core revision (both are in backports)
PCI ID first seen in kernel v2.6.17 (2006-06-18)
(see also passys)
Antenna connector: MC
bg
FCC ID | |
---|---|
Buffalo WLI-CB-G54A | IXMCB-G-BR-02 |
USI CB-G-BR-02 | IXMCB-G-BR-02 |
For a list of all currently documented Broadcom chipsets with specifications, see Broadcom.
lspci -nnv dump
06:00.0 Network controller [0280]: Broadcom Corporation BCM4306 802.11b/g Wireless LAN Controller [14e4:4320] (rev 03) Subsystem: Melco Inc Device [1154:0324] Flags: bus master, fast devsel, latency 64, IRQ 19 Memory at f1d00000 (32-bit, non-prefetchable) [size=8K] Kernel driver in use: b43-pci-bridge
ssb + b43 info dump
[34639.165401] ssb: Found chip with id 0x4306, rev 0x03 and package 0x00 [34639.165411] ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x04, vendor 0x4243) [34639.165421] ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev 0x05, vendor 0x4243) [34639.165431] ssb: Core 2 found: PCMCIA (cc 0x80D, rev 0x02, vendor 0x4243) [34639.165441] ssb: Core 3 found: V90 (cc 0x807, rev 0x02, vendor 0x4243) [34639.165450] ssb: Core 4 found: PCI (cc 0x804, rev 0x09, vendor 0x4243) [34639.169300] ssb: Sonics Silicon Backplane found on PCI device 0000:06:00.0 [34639.180832] b43-phy8: Broadcom 4306 WLAN found (core revision 5) [34639.203151] b43-phy8: Found PHY: Analog 2, Type 2 (G), Revision 2 [34639.231260] Broadcom 43xx driver loaded [ Features: PNL ] [34639.232992] ieee80211 phy8: Selected rate control algorithm 'minstrel_ht' [34639.407148] b43-phy8: Loading firmware version 666.2 (2011-02-23 01:15:07) [34639.472176] IPv6: ADDRCONF(NETDEV_UP): wlan187: link is not ready