TP-LINK TL-WDR4300
TP-LINK TL-WDR4300 v1.1
Availability: common
FCC approval date: 06 June 2012
(Est.) release date: 13 June 2012
UPC: 845973051938 (UPC DB, On eBay)
Country of manuf.: China
Series: N750
Type: wireless router
FCC ID: TE7WDR4300
IC ID: 8853A-WDR4300
Power: 12 VDC, 1.5 A
Connector type: barrel
Conn. measurements: 5.5 mm (OD), 2.1 mm (ID), 9.5 mm (LEN)
CPU1: Atheros AR9344 (560 MHz)
FLA1: 8 MiB8,388,608 B <br />65,536 Kib <br />8,192 KiB <br />64 Mib <br />0.00781 GiB <br /> (Spansion S25FL064KIF)
RAM1: 128 MiB134,217,728 B <br />1,048,576 Kib <br />131,072 KiB <br />1,024 Mib <br />0.125 GiB <br /> (Hynix H5PS5162GFR × 2)
Expansion IFs: USB 2.0
USB ports: 2
WI1 chip1: Atheros AR9344
WI1 802dot11 protocols: bgn
WI1 MIMO config: 2x2:2
WI1 antenna connector: RP-SMA
WI2 chip1: Atheros AR9580
WI2 802dot11 protocols: an
WI2 MIMO config: 3x3:3
WI2 antenna connector: RP-SMA
ETH chip1: Atheros AR9344
Switch: Atheros AR8327N
LAN speed: 1G
LAN ports: 4
WAN speed: 1G
WAN ports: 1
abgn
Default IP address: 192.168.0.1
the IP 192.168.0.1 is used by 785 additional devices
of which 97 are TP-LINK devices
Default login user: admin
Default login password: admin
admin:admin credentials used by 1327 additional devices
of which 277 are TP-LINK devices
For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.
N750 Wireless Dual Band Gigabit Router
See also the TP-LINK TL-WDR4310 which shares the same hardware.
- The Mercury MW4530R probably (on the OpenWrt Forums)
- also shares the same hardware (minus a USB port).
"2050500224 Rev:1.0" is silkscreened on the board in the FCC photos.
- A Genesys Logic GL850G USB 2.0 Hub controller is in use.
Additional external links
- "2050500231 Rev:1.0" is silkscreened on the board photo (v1.1).
- TP-Link TL-WDR4310 v1.0 First Steps on the OpenWrt Forums
- Working build on DD-WRT Forum
- CES 2012: TP-Link Announcements - SmallNetBuilder
HW Versions
v1.7
- RAM: Zentel A3R1GE40CBF
- Flash: Winbond W25Q64FVSIG
v1.6
- RAM: Winbond W975166KB
- Flash: Winbond W25Q64FVSIG
PSU
Power supplies, as shown in the FCC photos, are...
- US: Leader Electronics MU18-2120150-A1
- (100-240VAC ~ 50/60Hz, 0.6A -> 12VDC, 1.5A)
- Australia: Leader Electronics MU18-2120150-A3
- (100-240VAC ~ 50/60Hz, 0.6A -> 12VDC, 1.5A)
- UK: Leader Electronics MU18-2120150-B2
- (100-240VAC ~ 50/60Hz, 0.6A -> 12VDC, 1.5A)
- Euro: Leader Electronics MU18-2120150-C5
- (100-240VAC ~ 50/60Hz, 0.6A -> 12VDC, 1.5A)
JTAG
AR9344 Support two JTAG modes:
- Plain JTAG and EJTAG for debugging.
To enable EJTAG mode you will need to remove
- bootstrap resistor marked on this image:
EJTAG
If u-boot is not damaged and you won't to experiment with EJTAG,
- then you will need to disable at least /CS pin of SPI chip.
- You can see it on this picture too.
Images
- from TP-LINK
main
back
angled1
angled2
top
- from Fishor
