Westell VersaLink 7500 (A90-750015-07)/Bridge Mode

From WikiDevi.Wi-Cat.RU
Jump to navigation Jump to search

Changing the Westell VersaLink 7500 to Bridge Mode

In order to use third-party routers with your Westell VersaLink 7500 gateway,

you must first change your VersaLink gateway to Bridge mode.

Note: The setup screens may vary slightly from the ones included below, depending

on when you purchased your VersaLink gateway and the firmware running on it.

To change your Westell VersaLink 7500 gateway to Bridge mode

1.Log in to the Westell VersaLink 7500 gateway by entering

http://192.168.1.1 in your browser’s address bar.

Show Me

2.When prompted, enter your gateway's user name and password.

Show Me

Note: The default User Name is admin and password is password.

3.From the main menu, click My Network.

Show Me

Updating the connection settings

4.Click Network Connections in the left navigation panel.

Show Me

5.Click Broadband Connection (DSL).

Show Me

6.Under the VC’s section, click the Edit icon.

Show Me

7.Select Bridge from the Protocol drop-down menu.

Show Me

8.Select routed bridge in the Bridge Mode field.

Show Me

9.Click OK to confirm you want to reset your modem.

The Westell gateway will now reset itself.

Show Me

Turning wireless off

10.Once the modem resets, the main page will display.

If the main page doesn't display, click Main.

Show Me

Note: When configuring the Westell VersaLink 327W or 7500 to bridge mode,

the wireless settings must be disabled.

Once the device is configured to bridge mode, you may then re-enable wireless.

11.Click Wireless Settings.

Show Me

12.Click Basic Security Settings in the left navigation panel.

Show Me

13.Turn off Wireless by selecting Off.

Show Me

14.Scroll to the bottom of the window and click Apply.

15.Click OK when the warning displays that

your wireless access will be interrupted.

Show Me

Changing the LAN settings

16.You will be redirected to the main page.

If the main page doesn't display, click Main.

Show Me

17.Click My Network.

Show Me

18.Click Network Connections.

Show Me

19.Click LAN.

Show Me

20.Remove the check from the Private LAN DHCP Server Enable box.

Show Me

21.Click Apply.

Turning wireless back on

22.Click OK if a warning displays that enabling

private LAN will disable public LAN.

Show Me

23.The modem is now in Bridge Mode.

Close the window if you don't want to re-enable wireless and continue with Step 26.

To enable wireless, continue with Step 22 - 25 below.

24.Click Wireless Settings.

Show Me

25.Click Basic Security Settings.

Show Me

26.Select On under "Turn Wireless On."

Show Me

27.Your VersaLink gateway is now in Bridge mode with wireless enabled.

Close the VersaLink configuration window.

28.The last step before you're ready to connect your third-party router

is to terminate any active TCP/IP connections on your network.