WikiDevi.Wi-Cat.RU:DD-WRT/WAN Port
Jump to navigation
Jump to search
per phuzi0n:
- For better performance you should use the VLAN GUI to reassign the WAN port to the same VLAN as the LAN ports. Using the "assign to LAN" option bridges it (software) in br0 which is limited by the CPU instead of switching (hardware) which is limited by the switch ASIC's.
When the WRT is used as an Access Point (AP) or repeater (WDS), the WAN port can easily be configured as a normal LAN port.
Adding WAN Port to LAN Switch to use as an additional, normal LAN port
Note: Steps are true for firmwares current as of the author date of this article. v2.4, post SP2 firmwares. These steps were done with build 12307 (2009 06 17), widely regarded as stable. Other firmware builds of DD-WRT have the same or very similar steps.
- Open up the Web Interface to your DD-WRT Device
- Set WAN 'Connection Type' to Disabled.
- Down the Basic Setup page, the option WAN Port appears. Check the box 'Assign WAN Port to Switch'.
- Save/Reboot
The WAN port is now the same as the other LAN ports.
See Also
- Dual / Triple WAN How To
- Dual-WAN for simple round-robin load equalization
- Dual WAN with one as standby backup
- Dual WAN with failover
External links
- DUAL WAN E2000 / WRT320N - WIP