Alpha Networks WMC-ND02

From WikiDevi.Wi-Cat.RU
Jump to navigation Jump to search

Alpha Networks WMC-ND02

FCC approval date: 27 April 2012

Interface: Mini PCI

Form factor tags: Mini Card

ID: 168c:0030 (16 addl. devices) SS: 168c:3112
Windows: PCI\VEN_168C&DEV_0030&SUBSYS_3112168C

FCC ID: RRK-G2F

WI1 chip1: Atheros AR9380

Additional chips
2.4/5GHz Front End Module;Skyworks;SE2595L;;3;

Windows driver
see ath-drivers.eu
(Win 7/8/10)

Antenna connector: U.FL

an, 3x3:3

OUI: 00:03:7F (3 E, 10 W)

For a list of all currently documented Atheros (QCA) chipsets with specifications, see Atheros.


802.11a/g/n PCIE Mini Card

From a card pulled out of a Western Digital My Net N900 Central (2TB)...

  • "8WMCND02.1A1G" is silkscreened on the bottom of the card.
  • "802.11 a/g/n PCIE Mini card" and "REV-A1" is silkscreened on the card on the top (underneath the RF shielding).
  • The card is using 3x SiGe SE2595L FEMs.
  • The card is locked into operating in the 5G band only - as a wireless module in the N900 Central, it is the 5G module.
  • The PCI ID used by the card is 168c:0030 (168c:3112). This is the same ID used by the sister module, the Alpha Networks WMC-N02.
  • The OUI hard-coded into the card is 00:03:7F.

I don't know if this module was used in any other devices other than the N900 Central or marketed to other companies, but, if so, the details will probably differ.

Linux command-line-tool-derived info from the N900 Central Card

lspci -nnv
05:00.0 Network controller [0280]: Qualcomm Atheros AR93xx Wireless Network Adapter [168c:0030] (rev 01)
        Subsystem: Qualcomm Atheros AR93xx Wireless Network Adapter [168c:3112]
        Physical Slot: 1
        Flags: bus master, fast devsel, latency 0, IRQ 19
        Memory at f1d00000 (64-bit, non-prefetchable) [size=128K]
        [virtual] Expansion ROM at f1d20000 [disabled] [size=64K]
        Capabilities: <access denied>
        Kernel driver in use: ath9k
        Kernel modules: ath9k
 • iw list
Wiphy phy1
        max # scan SSIDs: 4
        max scan IEs length: 2261 bytes
        max # sched scan SSIDs: 0
        max # match sets: 0
        max # scan plans: 1
        max scan plan interval: -1
        max scan plan iterations: 0
        Retry short limit: 7
        Retry long limit: 4
        Coverage class: 0 (up to 0m)
        Device supports RSN-IBSS.
        Device supports AP-side u-APSD.
        Device supports T-DLS.
        Supported Ciphers:
                * WEP40 (00-0f-ac:1)
                * WEP104 (00-0f-ac:5)
                * TKIP (00-0f-ac:2)
                * CCMP-128 (00-0f-ac:4)
                * CCMP-256 (00-0f-ac:10)
                * GCMP-128 (00-0f-ac:8)
                * GCMP-256 (00-0f-ac:9)
                * CMAC (00-0f-ac:6)
                * CMAC-256 (00-0f-ac:13)
                * GMAC-128 (00-0f-ac:11)
                * GMAC-256 (00-0f-ac:12)
        Available Antennas: TX 0x7 RX 0x7
        Configured Antennas: TX 0x7 RX 0x7
        Supported interface modes:
                 * IBSS
                 * managed
                 * AP
                 * AP/VLAN
                 * monitor
                 * mesh point
                 * P2P-client
                 * P2P-GO
                 * outside context of a BSS
        Band 2:
                Capabilities: 0x11ef
                        RX LDPC
                        HT20/HT40
                        SM Power Save disabled
                        RX HT20 SGI
                        RX HT40 SGI
                        TX STBC
                        RX STBC 1-stream
                        Max AMSDU length: 3839 bytes
                        DSSS/CCK HT40
                Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
                Minimum RX AMPDU time spacing: 8 usec (0x06)
                HT TX/RX MCS rate indexes supported: 0-23
                Bitrates (non-HT):
                        * 6.0 Mbps
                        * 9.0 Mbps
                        * 12.0 Mbps
                        * 18.0 Mbps
                        * 24.0 Mbps
                        * 36.0 Mbps
                        * 48.0 Mbps
                        * 54.0 Mbps
                Frequencies:
                        * 5180 MHz [36] (23.0 dBm)
                        * 5200 MHz [40] (23.0 dBm)
                        * 5220 MHz [44] (23.0 dBm)
                        * 5240 MHz [48] (23.0 dBm)
                        * 5260 MHz [52] (23.0 dBm) (no IR, radar detection)
                        * 5280 MHz [56] (23.0 dBm) (no IR, radar detection)
                        * 5300 MHz [60] (23.0 dBm) (no IR, radar detection)
                        * 5320 MHz [64] (23.0 dBm) (no IR, radar detection)
                        * 5500 MHz [100] (23.0 dBm) (no IR, radar detection)
                        * 5520 MHz [104] (23.0 dBm) (no IR, radar detection)
                        * 5540 MHz [108] (23.0 dBm) (no IR, radar detection)
                        * 5560 MHz [112] (23.0 dBm) (no IR, radar detection)
                        * 5580 MHz [116] (23.0 dBm) (no IR, radar detection)
                        * 5600 MHz [120] (23.0 dBm) (no IR, radar detection)
                        * 5620 MHz [124] (23.0 dBm) (no IR, radar detection)
                        * 5640 MHz [128] (23.0 dBm) (no IR, radar detection)
                        * 5660 MHz [132] (23.0 dBm) (no IR, radar detection)
                        * 5680 MHz [136] (23.0 dBm) (no IR, radar detection)
                        * 5700 MHz [140] (23.0 dBm) (no IR, radar detection)
                        * 5745 MHz [149] (30.0 dBm)
                        * 5765 MHz [153] (30.0 dBm)
                        * 5785 MHz [157] (30.0 dBm)
                        * 5805 MHz [161] (30.0 dBm)
                        * 5825 MHz [165] (30.0 dBm)
        Supported commands:
                 * new_interface
                 * set_interface
                 * new_key
                 * start_ap
                 * new_station
                 * new_mpath
                 * set_mesh_config
                 * set_bss
                 * authenticate
                 * associate
                 * deauthenticate
                 * disassociate
                 * join_ibss
                 * join_mesh
                 * remain_on_channel
                 * set_tx_bitrate_mask
                 * frame
                 * frame_wait_cancel
                 * set_wiphy_netns
                 * set_channel
                 * set_wds_peer
                 * tdls_mgmt
                 * tdls_oper
                 * probe_client
                 * set_noack_map
                 * register_beacons
                 * start_p2p_device
                 * set_mcast_rate
                 * connect
                 * disconnect
                 * channel_switch
                 * set_qos_map
                 * set_multicast_to_unicast
        Supported TX frame types:
                 * IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
                 * managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
                 * AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
                 * AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
                 * mesh point: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
                 * P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
                 * P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
                 * P2P-device: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
        Supported RX frame types:
                 * IBSS: 0x40 0xb0 0xc0 0xd0
                 * managed: 0x40 0xd0
                 * AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
                 * AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
                 * mesh point: 0xb0 0xc0 0xd0
                 * P2P-client: 0x40 0xd0
                 * P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
                 * P2P-device: 0x40 0xd0
        software interface modes (can always be added):
                 * AP/VLAN
                 * monitor
        valid interface combinations:
                 * #{ managed } <= 2048, #{ AP, mesh point } <= 8, #{ P2P-client, P2P-GO } <= 1,
                   total <= 2048, #channels <= 1, STA/AP BI must match
        HT Capability overrides:
                 * MCS: ff ff ff ff ff ff ff ff ff ff
                 * maximum A-MSDU length
                 * supported channel width
                 * short GI for 40 MHz
                 * max A-MPDU length exponent
                 * min MPDU start spacing
        Device supports TX status socket option.
        Device supports HT-IBSS.
        Device supports SAE with AUTHENTICATE command
        Device supports low priority scan.
        Device supports scan flush.
        Device supports AP scan.
        Device supports per-vif TX power setting
        P2P GO supports CT window setting
        Driver supports full state transitions for AP/GO clients
        Driver supports a userspace MPM
        Device supports active monitor (which will ACK incoming frames)
        Driver/device bandwidth changes during BSS lifetime (AP/GO mode)
        Device supports configuring vdev MAC-addr on create.