Manuf (OEM/ODM): SGE GAN5.PT168A-B REV1.0
FCC approval date: 13 November 2012
Country of manuf.: China
Type: wireless router, dsl modem
Power: 12 VDC, 0.5 A
Connector type: barrel
CPU1: Broadcom BCM6318 (333 MHz)
FLA1: 8 MiB8,388,608 B <br />65,536 Kib <br />8,192 KiB <br />64 Mib <br />0.00781 GiB <br /> (Macronix MX25L6406E)
RAM1: 64 MiB67,108,864 B <br />524,288 Kib <br />65,536 KiB <br />512 Mib <br />0.0625 GiB <br /> (EtronTech EM6AB160TSD)
Expansion IFs: none specified
WI1 chip1: Broadcom BCM43131
WI1 802dot11 protocols: bgn
WI1 MIMO config: 1x1:1
WI1 antenna connector: none
ETH chip1: Broadcom BCM6318
Switch: Broadcom BCM6318
LAN speed: 100M
LAN ports: 4
Additional chips
ADSL AFE;Broadcom;BCM6301KSG;;1;
Stock bootloader: CFE 7.232
Stock FW OS: Linux 2.6.30
For a list of all currently documented Broadcom chipsets with specifications, see Broadcom.
"GAN5.PT168A-B" and "REV1.0" appears to be silkscreened on the board in the FCC photos.
- This device probably uses BCM6318 and BCM43131.
OEM: SGE (T&W)
Serial
| Expand • Boot log • >>
|
CFE version 7.232 for BCM96318 (32bit,SP,BE)
Build Date: Tue Jul 30 10:10:48 CST 2013 (laixinliu@SZ01007.DONGGUAN.CN)
Copyright (C) 2005-2012 SAGEMCOM Corporation.
HS Serial flash device: name MX25L64, id 0xc217 size 8192KB
Total Flash size: 8192K with 2048 sectors
Chip ID: BCM6318B0, MIPS: 333MHz, DDR: 333MHz, Bus: 166MHz
Main Thread: TP0
Total Memory: 67108864 bytes (64MB)
Boot Address: 0xb8000000
Board IP address : 192.168.1.1:ffffff00
Host IP address : 192.168.1.100
Gateway IP address :
Run from flash/host (f/h) : f
Default host run file name : vmlinux
Default host flash file name : bcm963xx_fs_kernel
Boot delay (0-9 seconds) : 1
Board Id (0-5) : F@ST1704N
Number of MAC Addresses (1-32) : 11
Base MAC Address : 68:15:90:ea:9b:46
PSI Size (1-64) KBytes : 40
Enable Backup PSI [0|1] : 0
System Log Size (0-256) KBytes : 0
Main Thread Number [0|1] : 0
*** Press any key to stop auto run (1 seconds) ***
Auto run second count down: 1�1�0
Booting from only image (0xb8010000) ...
Code Address: 0x80010000, Entry Address: 0x802f9780
Decompression OK!
Entry at 0x802f9780
Closing network.
Disabling Switch ports.
Flushing Receive Buffers...
0 buffers found.
Closing DMA Channels.
Starting program at 0x802f9780
Linux version 2.6.30 (bensonli@sz01017.ads.local) (gcc version 4.4.2
(Buildroot 2010.02-git) ) #1 Wed Sep 18 18:54:02 CST 2013
HS Serial flash device: name MX25L64, id 0xc217 size 8192KB
F@ST1704N prom init
CPU revision is: 00029033 (Broadcom BCM3302)
DSL SDRAM reserved: 0x100000
Determined physical RAM map:
memory: 03f00000 @ 00000000 (usable)
Zone PFN ranges:
DMA 0x00000000 -> 0x00001000
Normal 0x00001000 -> 0x00003f00
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 -> 0x00003f00
On node 0 totalpages: 16128
free_area_init_node: node 0, pgdat 80391130, node_mem_map 81000000
DMA zone: 32 pages used for memmap
DMA zone: 0 pages reserved
DMA zone: 4064 pages, LIFO batch:0
Normal zone: 94 pages used for memmap
Normal zone: 11938 pages, LIFO batch:1
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16002
Kernel command line: root=31:0 ro noinitrd console=ttyS0,115200
Primary instruction cache 64kB, VIPT, 4-way, linesize 16 bytes.
Primary data cache 32kB, 2-way, VIPT, cache aliases, linesize 16 bytes
NR_IRQS:128
PID hash table entries: 256 (order: 8, 1024 bytes)
console [ttyS0] enabled
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 59908k/64512k available (3006k kernel code, 4584k reserved,
586k data, 136k init, 0k highmem)
Calibrating delay loop... 331.77 BogoMIPS (lpj=165888)
Mount-cache hash table entries: 512
--Kernel Config--
SMP=0
PREEMPT=0
DEBUG_SPINLOCK=0
DEBUG_MUTEXES=0
|
