regarding the images on D-Link DWL-AG132 rev A1.. are those indeed from a A1 unit? if so, is it an EU/RU/(other non-US region) unit? the Alpha P/N on the board matches that of the D-Link DWL-AG132 rev B1, the A1 should be a Global Sun / Cameo unit..
- --M86 (talk) 16:37, 5 April 2013 (EDT)
- No, i'm not sure. There is no additional information on the cover of this stick. I purchased it over Ebay from USA. There is only some more info insight: P/N BWLAG132NA50CB2
- the trailing two characters of the P/N are the revision, I think..
- Sounds plausible. Can we verify it?
- --Fishor (talk) 03:40, 7 April 2013 (EDT)
- probably not conclusively, but it seems to fit the pattern used with other D-Link stuff.
- D-Link DIR-501 rev A1 (Alpha) - P/N on device label is BIR501ANA....A1, revision A1, North American region
- D-Link TM-G5240 (Alpha) - P/N on device label is TEDI524ANA...A2, revision A2, North American region
- D-Link DI-634M rev B1 (Cameo) - P/N on device label is BI634MANA.B1, revision B1, North American region
- D-Link DWA-645 rev A - P/N on device label is GWA645EU.....A2G, revision A2, presumably European region (images submitted by Rt61)
- etc, etc, etc
- --M86 (talk) 21:11, 7 April 2013 (EDT)
ram size changes
- Hi, currently i port barebox boot loader to ar2315, ar2316, ar2317. This WiSoCs have 16 pins for SDRAM data transfer. According to documentation it support only 16bit data bus mode. It means, it is possible to use one 16bit SDRAM or two 8bit DDR-SDRAM... I think there can be a bit more variations. But, if there is only one SDRAM chip, it is defiantly in 16bit mode too. If SDRAM support different modes, then: 4bit - 64MB; 8bit - 32MB; 16bit - 16MB. --Fishor (talk) 13:41, 14 November 2013 (EST)
- Oops. you was right... --Fishor (talk) 17:29, 14 November 2013 (EST)
Can you give detail about how do you get the JTAG info, for example in Ralink RT3352 ? Is it visible from software side, for example using ls /proc/jtag/whatever, or only visible using special hardware?